Looking for a digital voip service to use with your Siemens / Gigaset phones? Click HERE to view our multi-line voice plans and pricing.
1) Go to http://www.gigaset-config.com and log in using default PIN 0000. If that logs you in, skip to step 2.
If that doesn't route you to phone, you'll need to find the specific IP address of the device. The exact steps to do this depends on the model of phone that you have, and may be one of the following methods:
- Using your phone handset select Menu > Settings > Base > Local Network > System Pin > IP Address
- Alternatively, you may need to use the following path: Menu >Settings > System > Local Network > System Pin > IP Address
Using your web browser connect to that IP address into the address bar. Example: if the phone displays 192.168.001.010, enter 192.168.1.10 into the browser.
Once logged into the base unit enter 0000 as the default PIN.
2) Click Settings tab from the top of the screen, followed by Telephony from the left hand menu. Now select the edit button under IP Connection and click on Show Advanced Settings.
The following will need to be entered into the relevant box's displayed on the screen:
- Authentication Name: your phone or extension number
- Authentication Password and Confirm Authentication Password: your sip password or secret
- Username: your phone or extension number
- Domain: [enter a CLONE LINE server]
- Display Name: your phone or extension number
- Proxy Server Address: [enter a CLONE LINE server]
- Proxy Server Port: 5060 [or other supported port]
- Registrar Server: [enter a CLONE LINE server]
- Registrar server port: 5060 [same as above]
- STUN Enabled: No [optional yes if you need to tunnel through your firewall]
- STUN Server: leave blank [you can use stun.voisip.com if needed]
- STUN port: 3478
- NAT refresh time: 20 sec
- Outbound proxy mode: Always
- Outbound proxy: [enter a CLONE LINE server]
- Outbound proxy port: [same as port above]
- VOIP Volume: High
- Enable Annex B for G729: No
Please click on G726 and click Remove. This codec is not needed as it is not supported on our network.
Please click Set to save the settings to the base station.
